How to sync Feniex Fusion 1X/2X Dash Lights

Here’s how to wire Feniex Fusion Dash Lights:

1. Cut off the cigarette lighter plug.
2. Connect the black (12V-) wire to ground and the red (12V+) to an activated switch.
3. To change the patterns, tap the green wire to the black wire.
4. To activate mode 2, connect the white wire to a 12V+ switch.

To alternate light heads:

1. Set both light heads to the steady on pattern.
2. One light head must be programmed as master and the other as slave. To check the mode, hold the green wire to the black for 3-5 seconds.
3. For single color: If all LEDS turn on, it is in master mode. If no LEDS turn on, it is in slave mode.
4. For dual color, If all LEDS turn on, it is in master mode. If half the LEDS turn on, it is in slave mode.
5. To change the mode, hold the green wire to the black wire for 3-5 seconds.