How to sync Feniex T3 Surface Mount Grill Lights

Here’s how to sync the  Feniex T3 Surface Mounts:

1. To power the unit, extend the red wire to a 12V+ post. Extend the black wire to the ground post of the vehicle’s battery.
2. To sync both light heads together, you must cycle through the patterns by tapping the blue wire to the black wire to get to the steady on pattern. Hold the blue wire to the black wire for 3-5 seconds to check which mode is programmed. If all lights turn on, this indicates master mode. If none turn on, they are on slave mode. To change the mode, hold the blue wire to the black wire for an addition 3-5 seconds. Both lights must be programmed as master. Connect both red wires together, the blue wires together, and the black wires together.
3. To alternate the light heads, cycle through all the patterns by tapping the blue wire to the black wire to get to the steady on pattern. Hold the blue wire to the black wire for 3-5 seconds to check which mode is programmed. If all lights turn on, this indicates master mode. If none turn on, this indicates slave mode. To change the mode, hold the blue wire to the black wire for an additional 3-5 seconds. One light must be programmed as master and the other as slave. Connect both red wires together, the blue wires together, and the black wires together.